1、工程部英语培训 第六课,模具词汇,1.抛光：polish,2.排位图： layout,3. 视图：view drawing,4.油缸：hydraulic cylinder,5.计数器: cycle counter,模具词汇,6.模流分析：mold flow analysis,7. 机台吨位: press size injection machine ton,8.开模行程：daylight,9.隔林柱间距：tie bar distance,10.试模材料: sample material,二.句子表达,1.请给出产品外观要求,我们才能确定外形斜度. -Please provide the par
2、t surface requirement, then we could decide the draft angle.,2.因产品表面为纹面,所以产品外形度需大于3度,否则产品会拖花. -The part surface is grain, the draft angle must be over 3 degrees, otherwise,there will be scratch.,二.句子表达,3.根据模流分析的结果,我们建议变更浇口的位置(大小,类型) - According to the result of moldflow analysis,we suggest changing the location of gate.( the size of gate, the type of gate),
