1、IdeaPad S10-3s 拆装介绍,Analysis,1. Release battery lock and latch, take the battery out of computer.,Analysis,2. Loosen 3 screws of keyboard, and unsnap 4 latches to take the keyboard out of upper case,3X SCREWS M2*L2,Analysis,3. Remove the 6 screws of lower case and 4 screws on the keyboard plate,4X S
2、CREWS M2*L5,6X SCREWS M2*L8,Analysis,4. Distribute the lower case from system module;,L-CASE,SYSTEM,Analysis,5. Remove 2 screws form two hinges and open them; 6. Unplug the cables of the antenna and CCD then take them out from the orbits; 7. Unplug the LCD cable from system module;,2 X SCREWS M2*L5,
3、Analysis,8. Distribute the system module and the LCD module,SYSTEM MODULE,LCD MODULE,Analysis,9. Take the HDD away from system module; 10. Remove a screw of mini-card then take it away; 11. Take the DIMM away from system module;,1X SCREW M2*L3.5,Analysis,12. Remove 2 screws of fan then loosen the ca
4、ble connector and take it away; 13.Loosen the blue-tooth cable and remove it;,2X SCREWS M2*L3.5,BLUE TOOTH CONNECTOR,Analysis,14. Remove four screws from MB board and two of I/O board,1X SCREW M2*L2 UNDER KEYBOARD,5X SCREWS M2*L3.5,Analysis,15. Loosen the FFC touch pad cable and speaker cable connec
5、tors ;,Analysis,16. Remove the MB board and I/O board form the upper case;,17. Loosen two connectors of the cable and distribute them;,Analysis,18. Remove two screws of touch pad bracket and take it away from upper case;,TOUCH PAD BRACKET,2X SRCEWS M2*L2,Analysis,19. Push these two hooks then loosen
6、 it away from upper case;,TOUCH PAD COVER,Analysis,20. Remove two screws of speaker then distribute it from upper case;,2X SCREWS M2*L3,SPEAKER,21. Remove 4 rubbers from LCD bezel;,Analysis,Analysis,22. Remove 4 screws on the bezel then take it out of LCD module;,4X SCREWS M2*L3.5,Analysis,23. Distr
7、ibute two bezel caps from LCD module;,Analysis,24. Remove 4 screws on the hinge bracket;,4XSCREWS M2*L2,Analysis,25. Take the power board out of A-cover by push the hooks; 26. Take the LCD out of the panel with the power board and LCD cable;,Analysis,27. Unplug two connectors which on the power board and LCD, then distribute them;,POWER BOARD AND LCD CABLE,LCD,
