1、 Sport Shoe Workflow: - 01: Load reference images onto sketch planes. - 01: Align to measured scale. - 03: Load Last. - - 09: Offset Last 3mm for sockLiner. - 09: Offset sockLiner 3mm for midsole base. - 09: Create midsole bite line profiles of left, right and base line views. - 09: Project bite lin
2、e curves on midsole base and connect to form continuous 3D profile surround bite area. - - 10, 11: Copy profiles of base lines up into sole and scale smaller. - - - 12: Loft from base profiles up to each smaller profile. - - Form the entire midsole block: o Reduce the data in the 3D biteline by abou
3、t half. o 13: Create midsole wall profile curves from 3D bite line to baseline. o o 14: Adjust profile curve for slight arcs. o 15: Shape the wall forms of the midsole from the base profile up to the 3D biteline. o o o 16: Frame out curves of arch area and shape and blend with carving tools. o o 17:
4、 Smooth transitions from midsole walls through arch. o 17: Check piece to piece thickness in arch or min thickness to sockLiner. o o 18: Create midsole and outsole boundary curves. o o 19: Trim midsole back to boundary. - 20: Deboss area above profile 5mm to create midsole biteline, make sure sockLi
5、ner is visible so when deboss occurs the resulting edge is clear. - - 22: Create sketch curves for grooves on lat side and project on clay. - 22: Create sketch curves for grooves on base and project on clay. - - 24: Create sketch curves for med side ridge emboss and project on clay. - 25: Emboss rid
6、ges on med side. - - 26: Load in and upsample midsoleForm and select arch sweep from it, copy and paste as a new piece. - 26: Upsample sockLiner and Select arch sweep section from it, copy and paste this as a new piece. - 26: Move out the sockArch and midArch pieces (2 and 1.5 respectively). - - 28:
7、 Sketch soleplate profiles offset from the base line profiles. - - 29: Select with profile and create new solePlates piece, move down correct amount and trim off excess. - - 31, 32: Create curves for torBar and select clay, copy and create new piece with them. Remove sockliner from it and move down
8、slightly. - - 33: Create curves for gruvTex area, select clay (check for high enough res), and copy and paste to a new piece. - - 34, 35: Texture gruvTex area with noisyDark dots, and lower 1.5mm. Trim height so it becomes a set of narrow strips. - - 36,37,38: Create soleplate pattern of dots and emboss in 1.5mm. - - 39: Add midsole median layer 1.5mm offset from midsole blok. - - 40: Add color per piece. - -
