1、 Chery Automobile Co., Ltd Enterprise StandardQ/SQR.04.*2006Semiconductor cooler the location of the mark shall be stipulate in the drawing. 标记必须清晰且不可消除，标记所处的位置应在图纸上规定。4.2.2 Dimension and tolerance. 尺寸与公差According to related drawing and/or refer to the basic sample. 根据相关图纸规定和/或参照基本样品。4.2.3 Material
2、材料According to related drawing and/or refer to the basic sample.4.2.4 Surface Painting 表面涂装4.3 According to related drawing and/or refer to the basic sample.4.4 Design Speciality 设计特性4.4.1 Technical Requirement 技术要求4.3.1.1 Appearance Requirement 外观要求The surface of box body shall be flat, clean, same
3、 color, and shall not have scratch, crack, crinkle, deflated, distortion, etc defects. The liner shall not have draw trace, crack and same color without oil dirt. 箱体表面应平整、光洁、色泽一致，不应有划痕、裂纹、起皱、缩瘪、变形等缺陷；内胆应无拉痕、裂痕、色泽一致和无油污等。4.3.1.2 Structure Design Requirement 结构设计要求The design of cooler Second, test for
4、 1 hour under room temperature; Third, test for 3 hours under the temperature （-402 ）; Fourth, test for 1 hour under room temperature; At last test for 4 hours under the temperature （382） and Relative humidity 96%-98%. 先在（902）的温度下测试 3h，再在室温下测试 1h，再在（-402）温度下测试 3h，再在室温下测试 1h，最后在（382）、相对湿度为 96%-98%的条件
5、下测试 4h，如此循环 3 次。实验后满足功能要求。4.4.6 Alcohol Resistance Test 耐醇性试验Under the condition of room temperature, the cooler & warmer box can meet the performance requirement after steeped in the mixture of 50% alcohol and 50% water for 24 hours. The test is made by using carbinol and ethanol at each time and e
6、very time shall use the new sample. 在室Q/SQR.04.*20065温条件下，冷暖箱在 50%的酒精和 50%的水的混合物中浸泡 24h，分别用甲醇、乙醇测试,每次用新的样品；实验后满足功能要求。4.5.1 Vehicle Load Test 车载试验After the vehicle load test for 30,000 km on the city road, highway, mountain road, etc ,the semiconductor cooler & warmer box can be used normally. The appearance shall not have the break, scratch, distortion, crack, loose, etc. 经过城市综合路面、高速、山路等路面 3 万公里的车载试验后，半导体冷暖箱仍然能正常使用，外观在正常使用非人为因素不得出现破裂、划痕、变形、裂缝、松动等缺陷。Prepared by:Proofread by:：Reviewed by:：Approved by:Q/SQR.04.*20066Version： 00
