1、 Cover pageTitle: Authors: The first authorThe second authorThe third authorPAPER DEADLINE: *Check with Editor*PAPER LENGTH: *Check with Editor*SEND PAPER TO: Aristomenis G. SiskakisDepartment of MathematicsUniversity of Thessaloniki54124 ThessalonikiGreeceTel: +30 2310-997936Fax: +30 2310-994308E-m
2、ail: siskakismath.auth.gr- NOTE: Sample guidelines are shown with the correct margins.Follow the style from these guidelines for your page format.Hardcopy submission: Pages can be output on a high-grade white bond paper with adherence to the specified margins (8.5 x 11 inch paper. Adjust outside mar
3、gins if using A4 paper). Please number your pages in light pencil or non-photo blue pencil at the bottom.Electronic file submission: When making your final PDF for submission make sure the box at “Printed Optimized PDF” is checked. Alsoin Distillermake certain all fonts are embedded in the document
4、before making the final PDF.ABSTRACTBelow is a set of instructions for preparing your paper in a camera-ready or electronic file form (MS Word or PDF are preferred). Remember, if camera-ready, your manuscript will be photographically reproduced as received. It is most important that you follow these
5、 guidelines as closely as possible and adhere to the margins (discussed below) for overall consistency and format relationship to all other papers in the intended proceedings. Whether camera-ready or not, please follow the guidelines.PRINTING/TYPING YOUR MANUSCRIPT (first-order heading)The manuscrip
6、t must be typewritten or printed using a letter quality printer, e.g., a laser printer. The quality of print achieved with a dot matrix or thermal printer is not acceptable. Please type or print your manuscript on clean, white bond paper. Print or type text as close to the margins as possible withou
7、t going beyond these margins. The margins to be used for your paper are as follows: Top0.75” (19.1 mm) and Bottom1” (25.4 mm); Left1.3125” (33.3 mm); Right1.5625” (39.7 mm). Please use a regular bond paper (8 x 11 inches), and make sure that the width of the text is a maximum of 5.625 inches (143 mm
8、) and the depth is a maximum of 9.25 inches (235 mm). Adjust indents if using A4 paper.Use Times New Roman (the typeface used in these instructions), 12-point, at twelve characters per inch or in proportional spacing (as here). The camera-ready paper you provide to us will be reduced by 79%. Please
9、keep this in mind as you prepare your artwork.Use a new black typewriter ribbon or new printer toner so that type is as clear as possible. REMEMBER: All erasures, smudges, and the like will be reproduced. DO NOT type on page numbers. On each page of your manuscript, write the page number and authors
10、 last name with a light blue PENCIL near the bottom of the page or on the back of the page._Anthony A. Deraco, DEStech Publications, Inc., 1148 Elizabeth Ave. #2, Lancaster, Pennsylvania 17601-4359, U.S.AJoseph Eckenrode, Proactive Publications, 600 Pleasure Road, Lancaster, PA 17601, U.S.A.SUBHEADS
11、 (see figure 1 )(one line space from heading to text) First-order subheads should be in bold caps with 2 line spaces above and 1 line space below them. Second-order subheads should be in bold with main words capitalized with 1 line space above and below them. Third-order subheads should be in regula
12、r type in all caps with 1 line space above and below them. Subheads should not appear alone at the bottom of a page.Spacing (second-order heading)Do not leave a blank line between paragraphs. The first line of each paragraph should be indented 18 points (1.5 pica-6.3 mm-1/4”) space.(two line spaces
13、between text and first-order subhead)FIRST PAGEDEStech Publications, Inc. will insert the title and author name(s) in the space left blank on the top of the first page. The title and author name(s) should be supplied on a separate sheet (cover page) and submitted with the manuscript. The authors cur
14、rent affiliation, including full address, should appear as a footnote on the bottom of the first page in a 10-point Helvetica/Univers/Arial font. If authors are at different affiliations, please include names with affiliations. A 1-point rule (1 inch long/25.4 mm) should be no more than 1/8 inch (3
15、mm) above the affiliation. An ABSTRACT should begin the paper three and a half inches (89 mm) down from the top (to leave space for the title and author name). No illustrations, figures, or tables should appear on the first page.ARTWORKArtwork (photographs, tables, or figures) should be planned for
16、appearance at the bottom or top of a page, as close to the first mention of the artwork as possible; i.e., no text should appear both above and below artwork. If the artwork must be affixed to the pages (camera-ready only), please leave space in the text for it, but submit it separately. There shoul
17、d be between two and six blank lines between artwork (including captions) and main text and one blank line between artwork and caption (see Figures 1). Artwork should be centered between the left and right margins. In cases where artwork takes an entire page, it should be centered within the margins
18、. All print within the artwork should be in Helvetica/Univers/Arial font in the range of 8 point to 10 point (see Figure 2).(two to six blank linestext figures “boxed in”) FIRST-ORDER HEADINGS (e.g., ABSTRACT): bold uppercase; 2 line spaces above heading and 1 line space below heading. Second-Order
19、Headings (e.g., Spacing): bold; initial cap of main words; 1 line space above and below heading THIRD-ORDER HEADINGS (e.g., PHOTOGRAPHS): regular font; all caps; 1 line space above and below heading.Figure 1. Subhead specifications. (example of a text figure, text figures are “boxed in“)Transducers
20、Procesor Laliztin and mage estition Burst Genrator extsoiiof dage Figure 2. Example of figure.(two to six blank lines from figure to text or text to figure.)Tables and Figures (second-order heading)All tables and figures with text only should be boxed in; i.e., a box should be drawn around the table
21、 or figure either by hand with a ruler or with a draw facility on the computer (see Figure 1 sample and Table I sample). Labels for tables should appear centered at the top of the table in uppercase letters in a 10-point font. A Roman numeral should follow the word “TABLE”. Tables should be numbered
22、 consecutively throughout the text. In the case of figures (charts, graphs, photographs), the word “Figure” should appear preceding an Arabic numeral in the caption, which should be centered below the figure. Figures should also be numbered consecutively throughout the text. Captions must always be
23、printed or typed, not handwritten.PHOTOGRAPHS (third-order heading)Original black and white photographs ONLY should be submitted with your manuscript if you do not insert halftones into your article. Inserting a 300 dpi halftone is the preferred method. If photographs will be submitted separate from
24、 the main text, they should be clearly marked as to where within the text they belong.ILLUSTRATIONS Illustrations should be treated as “Figures” and labeled as such. Illustrations should be professionally drawn using black India ink (do not use blue ink) or created with a draw facility on the comput
25、er. Labels must always be printed or typed, not handwritten.(two to six blank lines from table to text or text to table.)TABLE I. EXPERIMENTAL AND CALCULATED DATA.Vf(%)I10-6/FT(F)/Tx 10-3/F55 1.1 150 1.9035T1.5 235 2.55 28.7435 1.5 235 2.4060 0.8 235 1.6060 0.8 235 1.6560 0.8 235 1.50MATHEMATICAL EQ
26、UATIONSMathematical equations should be centered between left and right margins and should be separated by one blank line. Any characters that cannot be typed (such as Greek symbols) should be hand-drawn using BLACK India ink. All equations should be numbered consecutively throughout the text, using
27、 Arabic numerals in parentheses along the right margin.i = 1 (1)a + b = c (2)REFERENCESThe first time a particular source (article, book, etc.) is cited in the text, it should be assigned a number and placed in the list of references at the end of the papersimilar to the list that follows. Each time
28、 this source is cited in the text, it should be referred to by its original number. Each number should be placed in brackets at the end of the referenced phrase before any final punctuation mark, e.g., as 2. A sample of listings is provided for a journal paper 1, a book 2, a chapter in an edited boo
29、k 3, an unpublished report 4, and a presentation at a conference 5. (If square brackets are not available to you, parentheses are acceptable.) References should be set in 10-point type.1. Ikegami, R., D. G. Wilson, J. R. Anderson, and G. J. Julien. 1990. “Active Vibration Control Using NiTiNOL and Piezoelectric Ceramics,” J. Intell. Matls. Sys. tel.: 717/290-1660; fax: 717/509-6100; e-mail: .6. For content questions, contact the committee chairperson or the person to whom you should send your paper.
